Home Heating

Set your home thermostat as low as comfortable (65 to 68 degrees F is suggested) when the house is occupied.
 

Set back the thermostat by as much as 10 F at night or when the house is unoccupied during the day.
 

Set back the thermostat to 50 to 55 F when the house is unoccupied for over 24 hours.
 

Install a programmable thermostat to automatically provide the setbacks mentioned above.
 

Close the fireplace damper – except during fireplace use.

Reduce heat to unused rooms in the house – close doors and heat registers too.
 

Close curtains and shades at night.
 

Replace furnace filters once a month during the heating season.
 

Remove any obstructions and clean heating registers regularly.
 

Have certified maintenance personnel service and check your furnace regularly – every three years for gas fired furnaces.
 

Seal all joints in sheet metal ducts in a forced air furnace with mastic or appropriate tape; insulate ducts passing through unheated spaces.
 

Minimize the use of kitchen, bath, and other ventilating fans or install a timer switch on them.
 

Install insulating gaskets behind electrical outlets and switch plates on exterior walls.
 

Caulk and weather-strip doors and windows.
 

Caulk and seal leaks where plumbing, ducting or electrical wiring penetrates through exterior walls, floors, and ceilings.
 

Upgrade ceiling insulation to R-38 (higher R values mean greater insulation levels and thus more energy savings).
 

Insulate exterior heated basement walls to at least R-11.
 

Insulate floors over unheated areas to R-19.
 

Install storm windows over single pane windows.
 

Replace aging furnace, when needed, with an energy efficient model.
 

Replace single pane windows with energy efficient double pane windows mounted in non-conducting window frames.

According to the US Energy Dept. Heating & Cooling
Heating and cooling account for about 56% of the energy use in a typical U.S. home, making it the largest energy expense for most homes. A wide variety of technologies are available for heating and cooling your home, and they achieve a wide range of efficiencies in converting their energy sources into useful heat or cool air for your home.
When looking for ways to save energy in your home, be sure to think about not only improving your existing heating and cooling system, but also consider the energy efficiency of the supporting equipment and the possibility of either adding supplementary sources of heating or cooling or simply replacing your system altogether.
Your contractor should be able to give you energy fact sheets for different types, models, and designs to help you compare energy usage. For furnaces, look for high Annual Fuel Utilization Efficiency (AFUE) ratings. The national minimum is 78% AFUE, but there are ENERGY STAR models on the market that exceed 90% AFUE.
Place heat-resistant radiator reflectors between exterior walls and the radiators.
Bleed trapped air from hot-water radiators once or twice a season; if in doubt about how to perform this task, call a professional.
Clean warm-air registers, baseboard heaters, and radiators as needed; make sure they're not blocked by furniture, carpeting, or drapes.
Clean or replace filters on furnaces once a month or as needed.
Use fans during the summer to create a wind chill effect that will make your home more comfortable. If you use air conditioning, a ceiling fan will allow you to raise the thermostat setting about 4°F with no reduction in comfort.
Turn off kitchen, bath, and other ventilating fans within 20 minutes after you are done cooking or bathing to retain heated air.
Install a programmable thermostat that can be adjust the temperature according to your schedule.
ENERGYSTAR labeled products can cut your energy bills by up to 30 percent. Find retailers near you at http://www.energystar.gov/ when you’re ready to replace your heating and cooling systems – as well as appliances, lighting, windows, office equipment, and home electronics.
Insulate your hot water heater and hot water pipes to prevent heatloss.
Insulate heating ducts in unheated areas such as attics and crawlspaces and keep them in good repair to prevent heat loss of up to 60 percent at the registers.
Heating can account for almost half of the average family's winter energy bill. Make sure your furnace or heat pump receives professional maintenance each year. Look for the ENERGYSTAR label when replacing your system.